You usually do not need to filter for generic trap message numbers if the OID is unique. Specify a generic trap number to filter trap messages that use the same OID for more than one trap message. You can use this parameter for any trap however, this parameter uses SNMP v2 terminology. If you leave this parameter blank, the script reports events related to the entire MIB tree. Separate multiple sub-trees with a comma (,). Provide the part of the MIB tree (sub-tree) about which you want to receive events. ![]() 1.2.6.1., the script will not match all OIDs that begin with. ![]() NOTE:This script filters for an exact match to the OID you provide. If you are using OID notation, include the dot (.) at the beginning of the identifier. If you are using ODE notation, use a case-sensitive descriptor. If you leave this parameter blank, the script does not use the object identifier to filter for events. To filter for more than one object identifier, separate each notation with a comma (,). You can use OID or ODE notation to specify the object identifier. The object identifier is defined by the SNMP source agent. Provide the object identifier of the trap messages you want to receive. Trap Receiver can receive traps only from devices that are registered in net-snmp with the appropriate profile information: username, security mode, and passwords. ![]() For SNMP v1 and v2, leave this parameter blank (the default) to receive traps from any source IP address or hostname.įor SNMP v3, you must provide at least one IP address or hostname from which to receive traps.
0 Comments
Leave a Reply. |